Skip to content

Hot Water Speers Point

Speers Point Plumbing Co fixes, swaps and installs hot water for homes in Speers Point and the nearby lake suburbs. Whether the tank went cold overnight, is dripping at the base or is due for an upgrade, the price is fixed and agreed first. Ring (02) 4093 0558 or start with Speers Point Plumbing Co.

Licensed plumbers and gas fitters · NSW Lic. 359278C

Last updated September 2026

Plumber finishing a continuous-flow gas hot water install
Two plumbers removing an old hot water tank

Is the Old Unit Worth Fixing?

This is where we weigh it up, because the right call differs from one house to the next. A dead element or a sticking valve can be fixed, but a cylinder corroding at the bottom will eventually empty itself across the floor.

Repair makes sense when one part has failed

An element, thermostat, valve or pilot assembly can be replaced on its own, and a tank still well short of ten years with sound walls is worth keeping.

Replace it when the cylinder is going

Water pooling under it, rust-coloured hot water, or a tank past twenty years all point to thinning steel, and spending on parts for a corroding shell rarely pays off.

Waiting on stock? A loan tank keeps showers warm meanwhile.

Instantaneous hot water unit fitted under a sink

What Goes Wrong With Hot Water Units?

The faults we diagnose over the phone and on site break into a few clear groups:

  • No hot water at all, which points to a failed element, thermostat or pilot
  • Water leaking from the base of the tank or around the valve
  • Lukewarm water or supply that runs out halfway through a shower
  • Discoloured, rusty water from the hot taps
  • A unit that trips the safety switch or the pressure valve

Each one points to a different fix, and the diagnosis comes before the quote, never after.

Electric storage hot water unit after installation

The Systems We Fit and Fix

Our plumbers and gas fitters work on all six system types, so whichever you pick, one team does it.

Electric storage and instant units

An electric cylinder heats overnight or through the day and stores it, while an instant electric heater warms water only as it flows, which suits a one- or two-person unit. We repair, replace and install both.

Gas storage and continuous flow

A gas cylinder reheats a full tank in a short time, and a continuous-flow heater lights its burner the moment a hot tap is turned on. Both need a licensed gas fitter to connect.

Solar hot water

Area-level figures count 1,404 solar units across the district, and we repair their pumps, valves and panels as well as installing new systems.

Heat pump hot water

The district has 1,660 heat pump installs on area-level figures, and the technology behaves differently enough to carry its own page. The heat pump hot water run covers sizing, placement and the repair-versus-replace call for that technology in full.

Speers Point Hot Water Services

Each card below routes to the page that owns the job, so nothing gets explained twice:

Heat Pump Hot Water

Sizing, siting and fault-finding for units that pull heat from the air. The heat pump page carries the full run.

Gas Hot Water

Gas tanks and continuous-flow units, from a burner that keeps going out to a first-time install. The gas connection itself is explained on the gas fitting hub.

No Hot Water After Dark

A unit that quits at midnight is an after-hours call, and the emergency plumber page walks through the first steps.

Water Leaking From the Tank

A weeping tank can hide a bigger leak in the supply line behind it, and the leak detection page traces where the water is really coming from.

What Feeds Into a Hot Water Quote?

Hot water pricing moves with:

  • The system itself, since a heat pump and a small electric tank are different purchases
  • The plumbing changes needed, because an old galvanised supply line can force extra work before the new unit connects
  • Access to the old unit, with one tucked under a cottage floor slower to reach than one on a slab
  • Taking away the old cylinder, already counted in the price

Housing That Decides the Hot Water Job

The mid-century stock sets the pace

Fibro and brick-veneer houses from the post-war decades make up much of the suburb, and many of their tanks are now at or beyond replacement age. On census figures the median age is 45 and households average 2.4 people, and that is where sizing a new unit starts.

The infill keeps coming

Approval records for the area list 727 dwellings over five years, so new units go into fresh builds alongside the swaps in the older streets, and the two jobs are quoted differently.

The old supply lines complicate swaps

Foreshore cottages from before the 1970s can still carry corroded galvanised steel supply pipes, and restricted flow at every tap can mean the pipe needs attention before the new unit performs.

The Booking and the Job

  1. 01

    Ring or send the form

    Call (02) 4093 0558 or use the form to explain the fault. We ask enough to bring the right equipment the first time.

  2. 02

    A fixed price first

    A plumber inspects the job and names a fixed figure up front. Nothing gets started until you give the go-ahead.

  3. 03

    The swap itself

    The plumber drains and lifts out the old unit, fits the new one, and runs the taps until the water comes hot at every point.

  4. 04

    Covered for a year

    Every job carries our 365-day warranty on all work. If something we did isn't right, ring the same number.

What Customers Say

They gave us a prompt quote with different options and helped us with a temporary hot water tank while the new system arrived and was installed.
Karen

When We're Not the Right Call

A heat pump that keeps tripping the switchboard needs an electrician's diagnosis before any plumbing work starts, and that circuit belongs to a licensed sparky, not us. We point you there on the phone and stay on the plumbing side of the job. Everything on the property side of the water meter, though, is ours.

Hot Water Questions From Speers Point

Which hot water system suits an older cottage near the foreshore?

Size it to the people, not the building. Two adults in a small fibro cottage by the lake can get by on a compact tank, but five people showering back to back need far more stored or instant capacity. We work out the daily draw with you, then quote one fixed figure.

Can we stay home while the old tank gets swapped?

Yes. You can stay home during a straight tank swap, and cold water stays on for most of it. When the replacement has to be ordered in, we can set up a temporary hot water tank so the household still gets hot showers until it arrives.

Do you cover gas hot water as well as electric?

Yes. Electric storage, instant electric, gas, heat pump and solar units are all covered by the same licence, so one plumber handles any of them. Gas work is checked and tested before we leave, and the whole job carries the 365-day warranty on all work.

What happens to the old tank after a replacement?

It gets drained, disconnected and taken away for disposal, and that removal is part of the quoted figure rather than an extra at the end. Nothing gets left in the yard or the laundry for you to deal with afterwards.

Need a plumber? Call or send the form

Call (02) 4093 0558 or send the form below. Available 24/7, you see a fixed figure ahead of any work, and every job carries our 365-day warranty on all work.

Call (02) 4093 0558

Request a callback

Leave a name and number and a plumber will ring you back.

We use your details only to call you back about this job. See our privacy policy.

Call (02) 4093 0558 Get a quote